this is similar to the parent thing, but is made for a single edge razor to be installed untill it needs to be changed.
you will need the follwoing
1x m2 6mm long countersunk screw
1x m2 nut
1 single edge razor blade
- set one on the side slots on the blade in the pin (its inside the blade chanel, near the tip) and use as a hinge to seat the blade.
- move the blade around to get the center hole aligned with screw hole.
- hold the m2 nut in place and screw the m2 counter sunk screw in place, dont tighten yet
- move the blade as far to the tip as you possibly can and then tighten the screw down.
why did i use a m2
i have a ton left over from another project i finished, and a m3 is just too big for the hole in the blades i use, so i assumed they would be to big for adjustment.
why make this one over others
well i feel its safer then hoping the external kife dosent come out of place,
and you never have to go looking for a knife to use as it is built in.