uBITX radio project

by vk5zbr Jul 17, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Adrian, what size LCD is used?


its a 2.8in display

Sorry I didn't get back to you sooner, I didn't get a notification of a message.

Do you mean deeper going towards the back of the case? So I draw the left and right deeper, at the moment it is 180mm, you would want 230mm deep. Wider would just be the strips being made longer for the front and back?
Which sides the plain sides or one with vent?

HI again Adrian,
I was wondering, could you remake the stl files for me so the case is about 2" wider and 2" longer ?
i can pay you for it.


never mind.. i found it.. display bezel.


Cool. I wouldn't be surprised if I left something out. I'm thinking of doing another version of that file that doesn't have the back light option and maybe a TX and RX led hole. Have fun.

Hi Adrian,
I would like to print this..but in the files I downloaded, I do not see the front face ??
kevin rea
lancaster, calif. usa

Opps I didn't answer your question, Volume, Mic gain and RF power out

Hi RamKat.
I was a bit quick putting up my drawing on Thing. I have updated the files with some pictures too. You will see the first knob is for the original Ubitx pot with plastic shaft and the second for standard pot with knurled shaft. These can be purchased on eBay. they are design to press on. Im using ABS so it shrinks a bit. so they are over size to account for the shrinkage. is it doesn't fit with PLA etc make the slicer a few % smaller and try again. its taken me a few goes to get the size right with my ABS.

Looks great What are the three similar sized control knobs for? Volume and?