This is the Ultimate remix of the Slim Wallet made by Pentland Designs
Check out the original here: https://www.thingiverse.com/thing:1756637
Please read all of the text below before proceeding to print
This new version features a better leaver system which has a wider space for cards, it also sports a sturdy easy-access card or money clip on the front.
On the back it has another easy-access card "slot" which I personally use as a quick-dispense for my bus tickets (see photo).
The Lid has been improved to close properly without wiggling and has two small holes which are used alongside the Wallet Clip. You simply tie a fishing line between the two holes and the small hole Wallet Clip. The Indispensable Wallet goes into your back pocket while the clip goes into the front, it's simply a anti-theft feature which is optional (see photo).
The hinge is simply a piece of 1.75mm filament (I used PLA)
With regards to the leaver, you just have to kinda force it in. I found that placing it properly and then smashing it on a table works best XD
THE LATCH MUST BE PRINTED WITH SUPPORTS
I found that a Leaver Latch worked best because it could endure multiple uses without wearing down (I've tested both snap clips and button clips which broke after a few uses, probably because of how small the size must be)
Simply align and glue on the leaver latch using some contact cement or super glue.
I'm currently working on one which has rounded edges to improve the aesthetic values of this wallet
Overall, the print took me Approx. 5 hours using my Monoprice Select Mini
Any tips or suggestions are welcomed, as well as any likes and makes :)
Leaver Latch must be printed with supports, a brim is recommended.
The Clip is optional
Contact Cement or Superglue (for the latch)
Needle-nose Pliers (Used to remove supports. optional)
X-acto Knife (Used to remove supports. optional)
Extra 1.75mm filament (for the hinge)