This is an enclosure for Ramps1.4 + Arduino Mega 2560 / Re-Arm + LCD 2004 RRD + Raspberry pi 3
This box was designed to fit 2020 extrusion profiles such as Creality CR-10 / Anet E10 3D printers
Each part of the box is a separate plastic part.
Print one of each (no special settings required)
Each part can be screwed together using M3x8 screws. Thermoplastic screws are well fit for this kind of application.
This box is compatible with :
Arduino Mega 2560 or Re-Arm 32Bits
Raspberry pi 2 / 3
What to Print
Print one of each Stl file and you are ready to go
2018.09.18 - Added RSDoc Source files
2018.07.08: Added LCD facade compatible with WS2812 FC-100 RGB 5050 LEd module
You can glue each side on the base, it will increased the box rigidity.
There are 2 holes available at the bottom of Bottom.stl.
These holes are dedicated to help you glue this part to the base part:
Glue the parts together, insert 2 screws, wait a little bit and remove these screws.
f you don't remove these screws after gluing the parts together, the screws will prevent you from properly placing the box on top of the extrusion profile.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.