I designed this lightweight, ergonomic, and highly portable universal tablet stand. There are major benefits to this design compared to the others on this site. Firstly, this design was engineered to save you on filament/money, weight, and time. And secondly, because this design features two individual side pieces you're not limited to the length of tablet you prefer to use!
Donations would help out a lot!
P.S you can experiment with how you use this stand, I found that using to hold a drawing tablet also works fine as well!
Don't go beyond the recommended infill range. 30% is more than strong enough, 100% is a waste of time, money, and weight
I printed mine at a .25 layer height. In my opinion, a .1 layer height is unnecessary
if your tablet is thinner than 9mm or wobbles around in the stand you can glue foam pads in the tracks to keep the tablet firmly in place!