Contents
Tags
Design Tools
A part of these Groups View All
License


Liked By View All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing TagSummary
This is a remix of ShinyObjects' arch base, added the ability for the Ray Wu 3 wire round Male pigtails to pass through the bottom. The original design did not have enough room for the nut on the pigtail to fit through the hole. This design lets it pass out the bottom and has a little wire holding clip to keep it in place while staking it into the ground. I also left in place the original side exit hole for the female plugs to fit through if you prefer that method for the female end.
It accepts 1" SharkBite PEX tubing and 1/2" EMT.
Uses a 1/4" x 2" bolt with nut and washer to fasten the EMT to base.
Secure pex into base with two #8 x 1/2" sheet metal screws or similar. 1/2" screws should not penetrate the inside of the tubing, while keeping the PEX securely fastened to the base.
Print Settings
Printer Brand:
TEVO
Printer:
Rafts:
No
Supports:
No
Resolution:
.20
Infill:
25%
Notes:
I used 3 top layers and 3 bottom layers.