I didn't find a proper rolling pin in here so here is my design.
It is more of a toy because it is a little smaller but could be used in the kitchen as well.
Support is only needed for the bar. The handles can be printed without support since the bridge of the hole isn't big. Depending on your use case you should select a higher infill percentage.
Print all parts as provided and assemble it. It should be a tight fit. If not, just add some glue for the handles and you are ready to go.
Upload a make if you print it!
Tip me if you like it!
Print everything in the provided orientation.
If you print the bar in an upright position it will break way faster (believe me, I experienced this)
It should be a tight fit. If not, just add some glue for the handles and you are ready to go.