RoBox , 3d printed walking robot, moving Arms, Head and meter.

by RobotHut Jul 20, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

This is some very impressive work! I have always wanted to make a robot.
So I begin, I've printed the parts & ordered the motor, switch & battery holder.
I'm sorry if I have missed it in the video but what size screws should I buy fir this project?
I will post a "I Made It" post when done!

Thank you so much Rob.

23 minuets in on the you tube build video shows the head orientation when printing with no supports. Also all the screw sizes are in the video.

Yes the videos call out the screw sizes I used, But as I recall the large gears are held in place with 3mm by 12 mm screws and the smaller screws are #2 taping screws 5/16 long. But just about any thing you can find that is close will work, if a screw is too lose just add some glue or a screw a bit to tight drill out the hole.

Thankyou so much! M3 x 12mm were easy to source, for the other the closest i could find is M2.3x10mm Pan Head Self Tapping with a washer collar. I hope that will work. One last question how did you Orientate the head halfs on the build plate?