Co-workers gave me a hard time about how Hangry I can get. I figured "Safety First" ;) The only issue with it is the tolerances between the dove tail sections. I have attached .f3d as well as an Fusion 360 Link for download. If anyone knows how to correct the tolerances for 3D printing please make the adjustments and send it to me and I will upload. I am still a novice to F360.
Please post any makes or remixes! I'd like to see them.
Picture Support came from: https://www.thingiverse.com/thing:2104586. -Thank You
Print all the pieces.(Back Panel Print: For multi-color on letters, change filament at 3.5mm)
Check fitment of the Dove Tail joints. Make adjustments if necessary.
Assemble the bottom panel and both side panels.(Note: I used a clamp to hold the sides against the bottom panel for the next step.)
Slide the back panel down along the back sets of grooves.
Fit the top section on. (Make sure that the slot on the top panel is facing forwards).
Super glue the snickers bar shelf to the back panel.
Once dry flip it over and super glue the edges of the back panel to the sides (Note: I would not superglue the sides along the grooves, this will lead to excess coming out the front side as well as make it hard to fit correctly).
Super glue the picture support to the center of the back panel.
- Get a piece of 3mm glass and slide it in from the top slot.