This resinvat are design for good sealing, easy of installation and easy to built, as it only need hex screw and nuts..lot of it.
Due to stock vat from sparkmaker are prone to leak and warp, So plan to make a simpler resin for the sparkmaker. As one dont really need much effort to replace the fep. As the stock vat are really hard to do fep replacement.
additional item needed:
-silicon or rubber mat : 170mm 80mm 1mm
-22 M3 X 10mm "DIN912"
-22 M3 hex nut " DIN934"
how to make the gasket:
-Print the gasket template
-Trace the gasket template over the silicon mat
-cut the silicon mat till size
-to make hole for the screw, mark the hole base on gasket template and cut or drill throughout.
How to install the vat-
silicon gasket or o-ring
sandwich all together base on the number. 1 then 2 then 3 then 4.. tighten .. !! NOTE.. Do not over tighten . Hand tight will do, else you will spoil the nut slot on the bottom unit. it plastic..!!!
Anycubic kossel min K2
Recommend to use filament that will not deslove by acetone or ipa. like PLA or PETG
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.