These are the corner prints used to enclose my Z-603s. these will be attached to acrylic panels to close up both sides of the printer.
NOTE: one of these when installed will cover the SD card slot, for me this is not an issue but i will when i get chance design one that wont.
Parts required for both side panel closures (all links are from ebay, i have no affiliation to any of these sellers!);
16 x M3 x 4.1 threaded inserts (https://bit.ly/2JV0YIO)
24 x 6x3mm Neodymium magnets (https://bit.ly/2v6v86n)
2 x Acrylic plates cut to size (tbc)
16 x M3x8mm Button head screws (https://bit.ly/2NKQu0X)
Can be printed finer but just wanted to fast print, i printed with 2 shells.
Installing the magnets and threaded inserts.
Printing on my printer i can just push the magnets in and they are retained.
If your prints are loose or come out when attached and detached from the printer you can use a spot of 2 part epoxy to secure permanently.
The M3 inserts are designed to be either press fit or heat fit. The way i usually do this is using a cheap soldering iron an pushing them in when hot.