Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has a deep well feeder on the side that allows you to water from the side of the pot. The soil will wick up the water as needed to the roots of your plant.
It has an alternate fill spout on the side of the tower that runs the water through an inside the pot water aqueduct to the tank / well.
This was printed using 3D Bizard 3D Tech Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.
Bizard 3D Tech Wood PLA: https://amzn.to/2IwVWSr
My Printer: http://amzn.to/2BBYP4t
I used 1.2mm on all walls top and bottom.