If you have a Toranado TPGE SIDE MOUNT VERSION and need a way to anchor it to your newly upgraded x-axis 2020 v-slot rail this is for you. Once printed you will only need a 3m screw and a few nuts.
ANCHOR- Use 4 M5 10mm screws to attach this plate to the V-Slot gantry.
LEVER- Use an M3 screw and nut to attach to "ANCHOR".
PLATE- Use 4 M3 screws to attach this plate to the TPGE SIDE MOUNT, tight.
Turn lever to full right, lay the TPGE's new "PLATE" into the "ANCHOR" groove and then gently push top into place, securing it in place by turning the lever to full left.
I absolutely loved the idea and execution of the cited Quick Fit system and found a way to implement it. I changed some dimensions on the plates and added some strength to each part where the lever fits. I like how it turned out. It could use some improvements/refinements, but I'm just too busy and it works well for me. KUDOS to TORANADO3D, sonnylowe, and lukie80 for their good work. Thanks.
FOLGERTECH I3 2020 CHEDDA MOD
The lever needs rafts because the bottom is not completely flat, don't worry it isn't supposed to be. Also, the Lever's opening for the nut needs support. The other 2 parts need very minimal support if you print it flat (ie-correctly).
The PLATE lock thingy might stick a little when trying to push the parts together. Just file that leading-edge down a teeny bit. You want it to fit tightly, though.