Version 2 available and is a thinner mounting plate of 3mm VS 4mm resulting in faster printing times while retaining appropriate strength. Also added a hold down tab on the connector side of the SBC card as well as a few cosmetic repairs
A request was made for a mount for a Pi Zero-W with a relay. I did not have dimensions of the relay but I made a part
I cobbled this up. No mounts for a relay but that would be easily added (or just drilled) and I left plenty of room for one.
NOTE: I modified the stl just a little from the pictures as I shifted the bar between the USB and HDMI ports 2mm to the left (towards HDMI) to allow ample space for plugs