Two piece succulent planter with a small reservoir in the bottom to avoid water drainage onto the table the plant sits on.
Supports needed during printing for the edge of the planter to avoid sagging.
Designed to look like a sphere while still giving room on bottom for water to drain.A small reservoir was kept in the bottom to allow some water to sit after watering without getting water on whatever the plant sits on. Modeled to give the appearance of a continuous sphere.
Recommended use is to pebble over bottom hole to avoid losing too much soil during watering. After watering, let majority of water drain out and place over base.
Designed using OpenSCAD for easy changing of size, thicknesses and gaps.