This thing replaces the stock E3Dv6 hotend on a stock Prusa MK2s with the Multi-Material version 1 upgrade with Slice Engineering’s Mosquito hotend.This installation uses the existing mounts and 3mm hardware found on the Prusa MK2s-MMU. You will need to provide a short piece of PTFE tubing to complete the install as pictured.
PETG - 0.2 mm layer - 20% Infill
To get the 'HOT' and logo emphasis on the cover I used PrusaControl w/color change set at 29.2 mm
It is highly recommended that you use a new thermistor and heater cartridge. The existing ones in the E3Dv6 hotend have been bent 90 degrees and lay alongside the heat block which can make them brittle over time. The Mosquito has the cables coming out straight as they were manufactured and they do not touch nor run along the heat block.
I did not include a part cooling fan mount as I personally do not use one with PetG.
Video is at: https://youtu.be/RWsZhaWw1Ec