This is the first in a series of accessories for Skully, found here:
This was designed for the 2" version, but I'm sure you could scale it for the smaller sizes. Make sure to use supports cause printing was a little tricky. It took a couple of attempts to get it to print right. The nose piece, before reaching the top, is only held in place by the supports. So make sure you pay attention to this when slicing. Scaling it will be extra tricky, I'm sure
Would like to see what others come up with as well. Enjoy!
Take note: the nose piece can be an issue. The only thing keeping the nose piece in place during printing is the support material.