This is a microphone made for the uBITX QRP radio. This design uses the original hardware provided in the kit. You will only need a wire with a 3.5mm stereo jack which can be purchased in most 99c stores and 5x #4 machine screws (Or you could also use M3 screws). As long as the screws are about 8-10mm long they should be fine. This microphone is smaller than regular microphones and it was done on purpose. I have found that due to it's size, it tends to be fairly comfortable to be held in the hand as well as to push the PTT button. The wire clamp allows you to clamp the incoming wire in order for it not to break the wires of the microphone if pulled. Best of luck and 73.
Assembly and test video:
Does not require much infill. Make sure to have at least 3 solid layers on the top, bottom and sides just so it can withstand some damage. Print all parts except for the cable clamp with supports. Be sure to flip the front part in order for it to print on it's front.