USb was led outside for possible keyboard or bluetooth stick
Just one Antenna SMA hole the other is indicated and pre-printed for drilling out,
SD cards slot accessible from the outside,
and a place for the GPS PCB near the antenna,
Improved ventilation slots.
**Updated Final Version**
Holder for Display now included and a little bit bugfixed.
This is a Case for Raspberry with Display + SDR +GPS +Power with 3x18650
I used a Zendure A3 with USB-C load socket. Take it appart and put it in the spacing in the case.
Raspberry 3B and 2x NooElec NESDR Nano 3
If you buy the "NooElec Dual-Band NESDR Nano 3 Premium ADS-B (978MHz UAT and 1090MHz 1090ES) Bundle for Stratux, Avare, Fore Flight, FlightAware" Kit then you have the Cables and the Sticks you need.
A Fan with 25mmx25mm
A GPS Module for Raspberry
The rest you should have in your craft box.
2x Micro USB with 23AWG cables for Display and Raspberry.
A simple switch for main Power
Transistor and resistor for Gpio Fan Control.
And the electronic basic materials, cables, shrinking tube, soldering iron, solder,.....
You have any questions? Write it down!
You can use this case not just for Sondescanning i think.
Here is a link to my Amazon basket https://www.amazon.de/registry/wishlist/MWVN963LWUM2
Final Printout not complete with electronic
First test Version
,....and another two.