MGN Carriage Mount & MK3 Locker
I had a couple problems with the BLV Mod upgrade on my AM8. The M3 screws which hold the E3D Hotend would not tightened because the nut pockets would strip out and the nut would spin. Also the M3 screws threads are not strong enough and stripped out. I ended up using zip-ties to hold the MK3 Locker and E3D together until I could redesign and reprint parts. I increased the screw size to M4 and moved the nut pocket back so all sides of the M4 nuts are held in place.
Will require (2) M4 x 20~25mm screws. At least (2) M4 washers.
MGN Carriage Mount 18mm Capacitive Sensor Mount
LJC18A3-H0Z/BX Capacitive sensor mount. I had difficulty spinning the mounting nut when tightening so I increased the space on top of the sensor mount to allow for more room to tighten the mounting nuts.
3030 Fan Mount
I thickened the top and bottom of the 3030 fan mount because the first printed mount broke in half.
5010 Fan Mount
Added a recess to hold the M3 nut so it didn't spin when tightening the mounting screws for the 5010 fan.
Infill % used in printing are in the file name.