Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
draner68

Barboteur / Bubbler

by draner68 Aug 21, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Worked perfect for me. I printed it in the original orientation with 0.1 mm layer heighth and put the support placement at "Touching Build plate" in Cura like draner had suggested. I printed with 100% infill because I was afraid of holes and it would make for a more clear print since I'm printing with clear filament, however it seemed to still have holes in it when I put water into it and blew into the bottom of it. Once I had turned flow rate to 105% from 100%, it didn't have any holes inside of it. There's obvious stringing inside of the bubbles themselves, but truly that isn't a problem. Fantastic airlock

Hi, how do you print this? What part should go downface to the printing board? Thanks

Hi, In the original orientation, you need to add supports to the bed.
If you turn at 180° the bubbler, add "raft adhesion"

Dans la position d'origine, ajoutez des supports de type "contact avec le lit".
Si vous retournez a 180° le barboteur, ajoutez simplement une adhésion de type "RAFT"