I wanted a 2 tooth blade and placement for bearings with a 10mmOD
I will be also making one with replaceable contact points so you don't have to replace the whole blade every match for best performance.
blade is for this Plastic 1lb antweight combat robot
the first one i uploaded was the wrong file! i replaced it with the proper one.
8-30-18 -- new blade with half inch OD for a larger bearing
doing the first test print now with these settings:
Esun PLA pro Peak Green
walls/top/bottom all 5mm
layer and wall count 12
gear teeth on weapon are very small and it came out to 80.5grams might be a bit much.
adamdc does say he used the xml belts they may be a better fit for it
new blade(posted 9/2/18) that fits the FingerTech timing belts, this one is a 25 tooth seeing a got too long of a belt by mistake. i will also make one that is around 19teeth to be a direct replacement
added a hub for a 1" wide bar , uses m3 hardwere
the blade uploaded 8/30/18 fits the parts listed by Adam, the only thing different is i use a 1/2" OD bearing . check the remix link to get to his bot this is made for.