Have a rounded box for your stuff - now the box itself says what's inside.
Use the customizer to adapt the text and sizes as needed. You can print the box without supports:
- This version III now allows to enter the angle at which the box sweeps upwards from the print bed. By default its 55 degree, so it should print fine without supports on most printers. If you choose an angle of 90 degrees, its like the version II, harder to print, but a bit bubblier.
Note that the wiggle room between the top lid and the bottom container is by default zero. If your printer is not well calibrated, increase this value to e.g. .3mm, so the lid fits on the bottom container.
If you print the top lid separately and stop the print at .85mm and change the filament color, you will have the text on top nicely readable. (As in the pictures posted above)
If you like it, also check out my configurable text based creations, text box with lid, name plate, pyramid text, round text, sweeping name plate, sweeping name plate II and text storage, which is similar to this one, but without the lids. Have also a look at my configurable pack of dogs and rabbits. And the
Please post your makes as "i made one"! I am curious what my customizable designs are used for and wether printing works out well. Also if you have ideas or wishes, let me know.