Loading
Raynlaze

Windows Mixed Reality Wrist Strap Clasp (improved)

by Raynlaze Aug 29, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Funny story, these clamps proved to be stronger than the plastic tab that holds the strap. I snapped the strap right off the controller!

Works well. Only complaint is that the lever needs to be rotated 3 degrees so that it sits flush with the print bed.

How do you print the lever? what settings? because It fails to print the teeth (it can't print on air obviously...) and I can't seem to enable support for this model... any ideas?

You know, I just printed out of the original versions yesterday, and I discovered the same thing. The edges of the housing were very sharp and dug into my wrist. I'll definitely try out your remix.

I also noticed the same thing. I have an updated design (similar to this remix), but I haven't tried to print it.

Things that are grey are "thin walls" so you need to enable print thin walls to get them to print.