Dimensionally, it's about 120mm side-to-side and 130mm end-to-end.
- 15 Boats
- 15 Roads
- 6 Knights
- 5 Settlements
- 4 Cities
I don't own the other two expansions but I play with these two nearly every time I play, and the pieces just get out of hand!
I would recommend PETG for durability but the photo is in PLA and it worked out just fine!
Make sure your printer tolerances are up to snuff. Everything is designed to fit with no resistance, but the tolerances on the pieces themselves can be... not great.
Let me know which piece is too snug and/or loose and I can upload some alternatives if need be.
Because the part is so thin (8mm), I would not recommend anything over 0.1 layer height for the best finish on the fillets around all the edges. At this height, it takes me about 7 hours to run off and uses 33 grams of plastic.
The text underneath the settlements has a depth of 0.4mm, so you should be able to fill it to make it pop. Send a picture if you do!
I did some searching on google images and hybridized some of the ideas in to this. I am very pleased with the result, and I hope you are too!