So after seeing a couple post about how the motor mount on the FT Edge can become soft over time, I designed a support for above and below the mount to help stiffen up the area around the motor mount. I also uploaded the plywood pieces so anyone else who is scratch building can just print and go. I am including an ultra light version of the upper mount, I didn't use it because the supports either failed or stuck to the mount itself resulting in the print being torn apart from trying to get the supports off.
The upper mount should be put in after being built, but the lower will have to go on before the cowl gets mounted.
Some pieces don't need supports so use your judgement when it come to adding supports. The upper motor mount support is recommended to use supports, but the lower may not need it. I didn't use supports for the lower.