This is an Extruder Visualizer based on the epic John Cleese character from the Ministry of Silly Walks sketch by Monty Python.
Check out https://www.prusaprinters.org/visualize-extruder-motor-movements/ for more info on how to use it.
I started of by designing a version where only the leg would move. After some test prints I did not like the way it was going to fit the motor. Instead of continuing to finalize that design, I switched to a single piece design.
You can find 2 version of the one piece version:
- 'SillyWalks_OnePieceFlat' - this should not require support
- 'SillyWalks_OnePiece' - this requires support
I also upload the two unfinished versions of the 'leg only'-design, just i case they might be usefull for someone. (SillyWalks_LegBelow and SillyWalks_LegOnTop)