On larger printers CR-10 300mm and up the long bowden tube and "wire loom" can droop down onto the bed. this is a very elegant simple solution to that problem print (see print instruction) twist long into the top beam snap the retractable tag holder into place. done.
works very well. you may be able to snap it right around your loom. if its too thick just use 2 zip ties in a figure 8 set up (one around the loom snug one through THAT ONE but loose for the badge snap to latch onto as in the picture. very very effective and simple.
https://amzn.to/2PWKQuL $8 gets you 10 on amazon. they look the same size and should work either way. I have ordered the amazon ones and will update if they work.
BUT if you have a Dollar Tree Nearby visit their first
that is what I use and they are 3 for $1 at dollar tree.
make sure to use enough top and bottom layers so the "walls" of the slot are solid without infill!! (I used 6 top and 6 bottom) and use 4 perimeters.
Rock it a little bit if tough to install. make sure its fully cooled down or it might bend. tolerance should be very good. may need extrusion multiplier of 96 or 97% (which is what I print at)