A cigarette case I designed for my mother in law
I'm an enabler.
Holds 20 cigarettes smaller than 8.5mm in diameter
the walls, lid and bottom are 2mm thick
the internal height of the box is 100mm, 98mm to make sure the latch has room to slide freely, so a bit packing is necessary before putting store bought 100s in.
this isn't a problem for us since we pack our own and it results in the cig being about ~2mm shorter than a proper 100.
make sure to print the lid first, as you need it during the print of the main case!
during printing, at around 104.6mm up pause the print and place the lid in the slot to allow the printer to bridge the top properly.
Make sure the latch is facing down as it can interfere with the nozzle causing failure.