Take a look to the new parts and links for the pickup in this video of MTC+TPB highlift
NEW EXTRA PARTS
This parts are just for the ones who upload a make of the MyRCCar 1/10 Typical Pickup Body, so this is not a "pick and go" publication...
Today I add here some extra parts for your pickup. Those are by now:
- Bed trunk
- Front protection bars
- Side Step bars
- Side Step platform
- Anti-roll bars
I printed all the "bars" parts (black ones) in TPU so they survive many hits, the same as the rearviews. The trunk and the side step platforms are in the same PLA than the rest of the pickup
Just the Side Steps are my creation, the rest came with the 3d model, I just adapted them to 3d printing and added the proper features to mount them on the pickup.
NEW 23.5mm LIFT KIT for MTC Chassis
I published previousliy some adaptors to use the TPB with MyRCCar 1/10 MTC Chassis. I'm having some clearance problems with them and the extra big wheels, so i created a version of them or some adaptors/extenders to put the body 23.5mm higher. I add them here too... they are:
- Front bumper link 10mm shorter (Will allow you to mount the body 10mm to the rear)
- Front bumper holder 23.5mm lift
- Rear link 23.5mm extender (if you want to use your previous no-lift rear chassis holder)
- New Rear chassis holder to use instead of the extender
If you take a look to the links/holders I publish here, you will find some "front bumper" ones, but not the "front" ones... I actually don't use those, just the front bumper and rear ones. With this 2 links i can roll over the body, hit things... The TPU links and holders will absorve a lot of the hits so they are not transmitted fully to the car structure/chassis.