A complete case for 2-pair desktop speakers (Right 2) & (Left 2) -- mid-range and tweeter each side (from Logitech X-230 desktop speaker system). A subwoofer can be added to the system depending on the setup and type of amplifier used. I used the following amp: https://www.aliexpress.com/item/Aiyima-2-1-Subwoofer-Amplifier-Audio-board-6W-2-25W-Mini-Bass-Amplifier-HIFI-YD1517P-for/32859636036.html?spm=a2g0s.90423220.127.116.11424c4dmeOeS3
The speakers I used were salvaged from an old Logitech X-230 Computer Speaker system. I intend to make a wooden box/enclosure for the woofer (not in the model).
The case looks very elegant with the stand, which is not too high that the pair would sit nicely under a normal computer monitor with a stand.
The middle tube between each pair is made to route the cables and connections, so that the speakers (mid-range and tweeter of each side) join together in the middle and come out the back as a single pair of wires (+ & -). To do so, you need to drill a hole on both sides through to the tube in the middle, so you can route the wires through.
The speaker frame and the stand are silver in color while the body was printed in wood PLA.
Silver & Wood
Please print the body face-down! It won't look good otherwise...
All parts were glued together (speaker frame, stand, speakers, etc.) You can drill a hole for a screw to hold the speaker body to the stand. But I just used super glue which worked great. However, you need to sand and smooth both surfaces (i.e. stand and body) where they attach if using glue.
If using a glue to attach body to the stand...You need to sand and smooth the surface where both parts join before applying the glue.
Please note that you also need to drill a hole from each dome to the tube in the middle to route the wires through and make the connection in the middle.