Redesign of Keeeal's hex fabric to optimize for FDM printing.
Main changes include thicker links, simpler geometry, beefed up base and continuous center section.
Note: the coned center section design saves print time (prior design required individual deposition points for 12 tiny dots that often failed, but that are eliminated here) and provides the strength needed to eliminate the vertical links
Printing at either 0.15mm or 0.20mm layer height works great
I've uploaded a few sizes to save time and allow you to find one that fits your printer.
Recommended minimum settings (thicker is fine):
Wall thickness: 1.2mm
Top/Bottom Thickness: 0.8mm
As mentioned above, printing this at 0.15mm and 0.20mm both turned out great.