EEEkit Hygrometer (Humidity Sensor) Through Screw Mount for Dry Box

by fardog Sep 13, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Thanks for sharing this model. I just happened to buy the same Hygrometer as you, this is also the Hygrometer Richard reprap used for his drybox design. (i had to make %1 bigger for fit)
What did u use to cut your container to fit the mount?

nice; hope it works out for you! I used a dremel with a circle cutter and a cutting bit; these parts (both amazon links, non-affiliate):

It was a little awkward but worked out well enough; the plastic likes to melt up around the bit but if you move steadily enough it works out ok. The tools were what I had on hand; the other thing I considered was a standard hole saw, but I felt like it'd most likely bind up and crack the container.

I intentionally made the gaskets and lip on the mount wide to cover up any ugliness that the cutting might create, and it worked out great. Good luck!