Basic water fall-through cup for bathroom.
This is thin, as 1.6mm for all wall. width of bottom is may 57mm~60mm, If I remember correctly.
While I'm novice to using blender and 3d modelling I tried to make honeycomb shaped cup for bathroom but successed only for bottom bar)
0.1mm for layer height, tested with 0.4mm nozzle
I did with white; but does not matter
Because printing honeycomb shaped bottom is hard; It can be stringy. You can use support without detatching it you choose to use not zig-zag one, but like triangles: which supports holes good.