A two piece label for herb or flower gardens.
tomas3d.it PLA green and PETG (white)
green and white
This is a label I made for our herb garden. It is in two parts. The green holder and the white part where you can write. The white part clips into the green part. I made the green part in PLA but the white is PETG because it was the only white material I had at the time. They should clip together if you make in other materials too.
The idea is that you can turn the white plate over and write on the other side if you need to use it again for another plant for example. PLA is better because bio.
I suppose I could have made them thinner and lighter but I wanted nice strong ones!
Infill 10% but does not matter.