A mounting device to store your phone on the wall as it charges. The shelf part is wide enough to accommodate many phone sizes as well as bulky phone cases. These parts print without any required support material. The lower part of this build was designed to fit around the standard apple sized wall outlet plug, that comes with all iPhones. The parts are designed to snap together after printing, with no extra hardware necessary.
PLA 3D Solutech Printer Filament
I used standard PLA filament with an initial layer print temperature of 235 C, then down to a 215 C temperature for the remainder of the print. The bed temperature was kept at 70 C. When printing the upper part, I recommend a initial print speed of less than 20 mm/s, in order to print the small clips at the back of the part.