This is my version of a stand for my Wowstick 1F+ for the 64pcs set. I took what I liked from djalmaribeiro's and Picaboubx's versions and put them together.
In my print, I discovered the tolerances were a little too tight so I had to sand a little. I adjusted the model to give more space .
UPDATE: I added models sized 102% for those who want to avoid any tolerance issues and sanding.
There is 2 pieces to print, the base and the clip which attaches to the base (glue or no glue, up to you) and then clips onto the wowstick to keep it steady. (see pics)
There is 2 versions of the base, one with the Wowstick logo and one without.
Proto Pasta HTPLA
If you gonna print in the higher recommended temps of a filament, then I recommend you print at 102% to make sure everything fits without sanding.