Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

My Build Log of Scott_3D's Hypercube Evolution

by ArtieH Oct 28, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

I've enjoyed reading your build log, thank you for taking the huge amount of time necessary to document your experience and sharing (and your editing/grammar is much better then some of the writing I find in e-books!). I'm undecided as of yet if I'll attempt this, but I can count on your precious information if I decide to go ahead.

Thank you. Your comments are greatly appreciated. This build was and is a great learning experience; and I do mean learning experience. It seems that at each step there was a new hurtle to overcome; but the rewards were always worth it. I'm still tinkering and learning. The two things currently on my plate are:

  • New camera (Broke my last one. But I'm looking at salvaging it.)
  • 32 Bit upgrade using Re-Arm board.

Thanks again.

Great read, I dont suppose you could update with a bit more information about your process of installing the Pi 3?

The Pi write up is done.
OctoPrint on the Pi is fantastic. I should have installed this long ago.

That's one beautiful looking printer and a very detailed and informative build log. Thank you for sharing your build and knowledge. I'm looking to build one myself

Thanks, and you're welcome. I'm always glad to share.

Thanks for sharing. Nice work, lots of information.

You're welcome. Glad to share.