Sorry, the location of the hole for the pigtail was a bit too high, so the radio module RFI-RF-MOD does not fit properly. I put the hole down about 5mm so that there should not be any problems.
Likewise, I have the openings of the ports still enlarged, they were a bit too small.
All those who have downloaded the version from 12.11.2018 have to discard them and download the current one from today.
The changes affect the bottom and the top part.
Hi, I modified the old case.
This is now the Enclosure Version 2 without annoying, easily breaking fastening straps. Now you can screw the parts together with 4 screws (I have used 2.8 x 15mm but it also fits similar ones). For the screw guides, I had to widen the case by 3mm on the side where the HDMI port is located. To make sure that the plugs still fit in the openings, I have also extended this a bit. (I hope that's enough)
I have fixed the connection for the external antenna in the bottom right. This eliminates the fiddling when putting the parts together and also the problem with too short pigtails.
For fixing the Raspberry PI and the radio module board RPI-RF-MOD you need 3 screws 2.5 x 8 mm.
The case differs significantly from the original Charly case and do not match with this.
Information and sources for external antenna please read here: https://homematic-forum.de/forum/index.php
I recommend low resolution to ensure an exact match of the parts