Please use it at your own risk.
Fixed the problem that type B holder width is 0.1 mm narrow.
Because there was a problem interfering with parts of the case, we changed the design of Type B.
Type B was added.
Board size 25.15mm×48.15mm×1.6mm Type A
Board size 28.6mm×49.1mm×1.6mm Type B
I do not have type B board, so I have not confirmed whether it can be used.
Please use the test piece to check if your board can be attached to the holder.
You can save filaments if you can not use them.
V2 UPDATE 9/27/2018
Changed the method of holding the substrate.
Please see the movie of the link destination for how to install.
This is a holder for incorporating TL-Smoother PLUS into Ender-3.