This is a Deamcast case designed for the Odroid Xu4 single board computer which can play DC games very well. This is designed as a snap together case but some fine trimming may have to be done to snap together properly. Case dimensions should be already pre-saved at 4.25"x4.25" it will have to printed at these dimensions in order for the odroid xu4 to fit properly.
Find me on YouTube 8bit Flashback: https://www.youtube.com/channel/UCFhGP_J_TxhkAdKXR78QZsA
I used supports and rafts where needed printing in 1mm layers.
Extra work required to achieve realism.
1.I used an exacto knife and small putty knife to remove supports & rafts.
2.Sanded all parts with 120 grit.
3.Fit all electronics inside case some drilling and trimming required. Then removed electronics.
4.Used 2 coats of filler primer to fill imperfections then wet sanded 1st coat with 360 grit and 2nd coat with 600 grit.
5.Painted with matte white & matte gray.
6.Painted with matte clear coat.
7.Did detail paint for controller ports and buttons.
8.Applied decals for logos. Used Avery clear shipping labels.
drilled small hole through power button stem then secure with paperclip
spray paint i used
glued controller ports in place after all painting was completed.