A simple Bit holder for Makita 18v tools. This holder was designed with wider spacing than my other standard 3 Piece Holder to hold a 5/16 and a 3/8 Nutsetter bit along with 1x Driver bit as shown in photos. Or to hold a 3 Piece Socket adapter kit for Automotive use as shown.
The kit this holder was designed around can be bought here in Aus from Supercheap Auto stores.
Search my other files for alternate designs.
It is held in place by a single 15mm M4 bolt.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desired fit is achieved.
The example shown in the photos is printed in PLA above 80% infill and seems to be more than strong enough for home / garage DIY work.
Print this holder standing on its end.
If you wish to have the holder on the opposite side of the tool just Mirror the model in your slicing software.
Cocoon Create Touch - Aldi
Cocoon Create PLA
Printed on its end in PLA using a Brim (Probably not needed) with a 0.4mm nozzle, 220 degrees C Printing Temp and 50 Degrees C Bed Temp.
Check out my other Items for alternate designs.