I've printed out some of the other amazing stands on thingiverse but none of them were perfectly suited for the new Apple Watch series 4/5 (44mm). Therefore I decided to design my own stand and behold the result here.
The stand has a lid on the bottom. This serves two purposes:
- it hides the cable in the stand
- it hides the lower quality print caused by the support structure to print this thing.
Note: to release the charger once pushed in the stand, simply take a wooden skewer and stick it up through the bottom behind the charger and push it out.
Note2: Don't slide the lid in fully at once, slide it in 10% and pull it out, then 20% and pull it out, etc. This smoothens the support surface and allows the lid to slide in and out easily.
Printed with supports for the lid part of the body. The support connection surface will be concealed by the lid.