This is a re design of my Driver Bit holder for Makita 18v tools to fit on ALDI's Workzone Titanium 20v Drill and Driver. This holder was designed with wider spacing than my other standard 3 Piece Holder to hold a 5/16 and a 3/8 Nutsetter bit along with 1x Driver bit as shown in photos
This holder is able to hold the same 3 Piece Socket adapter kit as my Makita version but the 1/2 inch adapter cannot be slide into the holder all the way due to the tapered design of the tool. You can see this in the attached Photos. I may re design to fix this at some point.
Check out my other items for alternate designs.
It is held in place by a single 15mm M3 bolt or the bolt that is already part of the Workzone Tool.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desired fit is achieved
The example shown in the photos is printed in PLA above 80% infill and seems to be more than strong enough for home / garage DIY work.
Print this holder standing on its end.
If you wish to have the holder on the opposite side of the tool just Mirror the model in your slicing software.
Cocoon Create Touch - Aldi
Cocoon Create PLA
Printed on its end in PLA using a Brim (Probably not needed) with a 0.4mm nozzle, 220 degrees C Printing Temp and 50 Degrees C Bed Temp.
Check out my other Items for alternate designs.