This is a Pi1541-II Case for the Backoffice Show PCB for the Pi1541 software created by Stephen White.
This design is still a work in progress and various tweaks may still be required
Screws are required, self tappers 3mm
Update to the bottom sections of the case, they needed to be taller and a pillar was slightly in the wrong place for the HDMI port to be accessed.
Update to full case top sections, i could not quite fit my OLED screen and board.
Adjustment for tolerances for OLED screens.
Removed the separate parts as it is easier to print just the top with front already attached.
Moved front posts further back to give more room.
Moved the Pi closer to the edge, removed the large oled version because after testing it wasn't correct and needs a redesign i think. May be screen on one side buttons on the other. Also attached is the sketch up file (with current large oled), this file is a bit messy and i think for v1.5 or v2.0 i may start again.
Completely redesigned the case.
The pi1541-front.stl only requires support, others do not.
The old V1.4.1 is still available in zip
M2 screws are used to join Mid and Bottom together.
M3 screws are used to join Top to the base.