This is a remix of the Carving Pumpkin for Halloween by BurulaNikita.
We sliced it into 3 parts for easier support free printing and to be able to keep a nice hollow inside for a tea light. See print settings for advised settings.
Printed in Orange Daily PLA on the Ultimaker 2+ from PrintedSolid.com
Printed Solid Daily PLA PLA
Print in the orientations published. Bottom and middle upside down, top right side up.
The model is broken up into pieces so that it can be printed with no support.
The middle piece should be printed with 2-3 shells and 0% infill. I highly advise using adaptive layer height or the like to handle some of the overhangs.
The bottom and top are pretty easy. Print as you like.