Remix of Shira's AWESOME design.
Since the original design is very nice modeled, but lack in fuctionality due to a too tiny ring, I remade it with a taller strike plate and separate, bigger ring with a more dense infill (+45%) to make it heavier.
The head must be scaled 70%, print the ring and the strike plate as is (plus support).
The ring (part A and part B) must be assembled with the two alignment pins (cube and cylinder) , inside the mouth of the dragon
Technology Outlet PLA
Infill: 15% for the head, 45% for the ring
Support infill percentage:30%
Extra inflation distance:1mm
Support base Layers:1
dense support layers:3
dense infill percentage:70%
support pillar resolution:4
Horizontal offset from part:0,30mm
Upper and Lower vertical separation layers:1
Cooling fan:100%@layer 4
Print Time:about 24h @40mm/s