Searchlights for RC boat. These are designed around a 5mm bright white LED.
Print as a pair but print the stands separately as they require Brim & full support to print correctly.
If you find the stands are too wide after removing the internal support just warm them slightly & close the gap to match the housing.
Paint the inside of reflector silver before installing LED
As the printed parts are quite small use a brim on base & searchlights/reflectors.
Use brim & full support on the stands.
After removing brim & supports warm the stands to set upright arms to correct size for a tight fit to the searchlight body.
Paint the inside of reflector silver before fitting LED's or assembling.
I used 5mm Superbright white LED's.
if required you can also fit a clear plastic cover (cut from suitable material) to enclose front of light.