Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
tgclark

Apple Watch Charger Stand

by tgclark Oct 12, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Printed it as well (Tevo Flash, 0.2mm layers, 20% infill, no supports, no base) and it turned out ok. Connections were only bit fiddly ones (needed to shave bit off to get them to work), I think I would have preferred just making one without them (= just add some supports to make final overhang work) and print with 100% infill for more weight.

I am considering remix / similar design now but one which wouldn't require supports if e.g. printed with PLA. That implies slightly leaning design for the upper portion instead of flat underside, but I think I can work with that. Or I can just get lazy and not do anything at all :-)

Looks pretty good; I would rotate the Apple watch charger holding piece to be flat, not sure if I managed to rotate it in Cura quite straight. I will print it out the next time I am home long enough for pieces to come out though :-)

Fixed! Thanks for pointing it out.