It’s an Ech-O-Lantern!

I’ve been playing with Meshmixer lately and this was a good project to learn a bit more with. I’m still very much a noob though.

I modified the Makies Jack-O-Lantern to hold an Amazon Echo Dot. It is lowered in a pocket in the base to try and keep it hidden below the eyes, but with a raised platform for the speakers. The power cord routes through a hole in the back. I also cut off some of the bottom of the pumpkin to get rid of the crazy overhangs, so now only the mouth and the eyes MIGHT need support.

https://youtu.be/u6HvMEm7HeY
(Watch video with sound)

SeeMeCNC Artemis
Atomic Neon Orange UV PLA
S3D

UPDATE:

1. Added a reduced mesh version of the base. The quality should be the same!
2. I found that if you are using the dot speaker, it creates too much sound at high volumes inside the pumpkin and Alexa can't hear you! Low volumes are fine, as are external speakers.

SeeMeCNC

Artemis 300 ARP

No

Yes

.2 (or your choice)

10%

Just route the power cord through the hole in the back and plug it into the Echo Dot. I used the eye holes to catch the dot as I lowered it into the pumpkin.